General Boards > Off Topic

Alloy welding required

(1/2) > >>

ajm:
Folks, I need someone to do a small spot weld on an engine head so that it can deal the cylinder. It's for a kohler mower engine. The groove requiring attention is approximately 10mm long. Hopefully it's clear to see in the attached pic. We are at Woodford, north west of Brisbane. Anybody know someone who could do this job?

Sent from my HTC_0P6B6 using Tapatalk

Richard Puller:
https://www.facebook.com/CSFWELDERS/

This place is at Slacks Creek and specialises in that sort of stuff.  Not quite at Woodford though.

ajm:
It's a start. I'll look them up. Cheers.

Sent from my HTC_0P6B6 using Tapatalk

VALKIE:
Just be careful that you use someone who knows what they are doing.

Aluminium alloys differ in many and wonderful ways.

Alloy wheels used to have a nice little additive that turns them into a firework when you try to weld them.

Some engine components have some very specific alloys that may or may not weld or may deform.

I used to think welding cast iron was a B$#tch, but aluminium alloys make that look easy.

Good luck

ajm:
Thanks valkie. If I can't find someone up this way, I'll run it down to slacks creek next week.


Sent from my HTC_0P6B6 using Tapatalk

Navigation

[0] Message Index

[#] Next page