General Boards > Off Topic
Tool Kit for MUX
Alan P:
Some good tips there.
I always have at least two of those rubber tent mats that interlock to allow mt get under the car, without getting my clothes covered in dirt and prickles. Also a jacking block and a 3/4" square drive slide bar with a reduction to 1/2" to ensure I can get the wheel nuts undone. Although properly torqued to 85 ft/lb, the nuts seem to lock, requiring significant force to get them undone.
I was fortunate enough to pick up a see through socket set from Repco for $30 that weighs less than a a kilo and comes in a small case 270X280x50 mm. This is accompanied with a 1/2" square drive ratchet wrench and adaptor to be able to use the sockets in situations where the supplied ratchet wrench would be too weak.
Oh, a bottle of Loctite too.
Navigation
[0] Message Index
[*] Previous page
Go to full version